BambooLab H2D,X2D,P2S High Flow Hotend,Hardened Steel 0.6mm Nozzle

【Wide Compatible】High flow hotend for H2 series - H2D,H2S,H2C Left,P2S, X2D, with 0.6mm hardened steel nozzle. Please Note: H2D high flow hot end is compatible with A1 Series, but it will not improve volumetric speed. In other words, the high flow hot end performs the same as a standard nozzle on the A1 Series.
【Real High Flow: Save Up to 30% of Your Time】The h2 series high flow nozzle's optimized melt zone enables significantly increased volumetric speed, achieving up to 62.5% higher max volumetric speed and reducing print time by up to 30% with ease. The larger your model, the more time you save—especially for prints with extensive infills.
【High-Speed Precision: Sharp Details Every Time】Say goodbye to under-extrusion, rough surfaces, and loss of detail. Unlike standard high-flow nozzles, Bamboo's high yet consistent extrusion ensures crisp edges, flawless texturing, and ultra-smooth surfaces—every single time.
【Quick Swap Nozzle Design】Very easy to install! *Please ensure that the hotend has cooled down before swapping, and avoid touching the heat block (lower section of the hotend) to prevent any risk of burns.
Max. printing temperature 350 ℃. Upgrade now and print faster without compromise!
【Factory Pre-Tested Quality Assurance】To ensure zero clogs and perfect extrusion out of the box, every H2 Series hotend undergoes a strict factory calibration test using high-temperature test filament. You may notice a small amount of white or colored residue inside the nozzle tip. This is NOT a defect, grease, or used product. It is a sign of quality control. Simply heat the nozzle to your printing temperature and purge the filament; it will clear within the first few seconds of use, leaving you with a perfectly clean, high-performance hotend.

Location: DFW, TX