DAYBETTER COB LED Strip Lights, Tunable White(2700K-6500K) COB LED Lights with 3040 LEDs, 24V Adapter, RF Remote, Dimmable High Density Uniform LED Strip for Bedroom, Kitchen, Cabinet, CRI90 , 16.4ft

NO More Worries About Dark Spot: Unlike regular SMD LED strip lights with dark spots & discontinuous lighting, DAYBETTER 16.4ft COB Lights built-in 3040 LED beads(608 LEDs/3.28ft) can delivers more brightness and continuous linear light. Create brighter, softer, spotless, and more uniform light area. Also COB lights lighting area is more spacious than SMD lights, because COB LEDs beam angle is 180-degree but SMD LEDs beam angle only 120-degree
Adjustable Color Temperature: This tunable white(2700K-6500K) led lights are suitable for every moment of your day, no matter work on the day or relax at night, you can adjust the light for warm white, natural white, cold white (2700K/3200K/4000K/5000K/5500K/6500K). Also with higher color rendering index(CRI>90)
Convenient Dual Controls: RF remote control and touch control help you easily switch the brightness and customize the light features as needed, strip lighting is designed to be easy for use
Multifunctional: The led light strip can be set to turn off after 60 seconds, very convenience to use as kitchen lights, cabinet lights, shelf lights, display lights, kitchen decor, etc. And has a power-on memory function, which can keep your last lighting mode and help you remember the light color and brightness
What You Get: The package include 1*16.4ft COB LED Lights, 1*Remote Control, 1*Control Box, 1*24V Power Adapter, 2*Fixed Clips, 2*Transparent connector, 2*Long connector
DIY Tips: 1.Cut the light strip along the cutting marks. 2.Confirm that the positive and negative poles correspond to each other. （Please make sure two wires and two pins must on the same side if you use long connector.） 3.Please turn off the power and unplug the plug before connecting, peel off the adhesive paper first, then insert the strip into the connector at both ends. 4. Press the patch to make sure it is fully clamped
Notes: When the controller is not paired with an RF remote controller, it can be controlled by multiple RF remote controllers; when paired, the controller is only controlled by the paired remote controller; one remote controller can be paired with multiple controllers
Remote Pairing operation method: (1) Pairing: When the controller is not bound to a remote control, turn on the lights, press and hold the ON button on any remote control for 2 seconds, and the white light will flash twice to indicate successful pairing. (2) Unpairing: Turn on the lights, press and hold the OFF button on the bound remote control, or power on and off 3 times in succession to unpair, and the device will begin to flash white light continuously
(Note: Please do NOT roll up the strip light during use. The lights and power adapter are not water-proof. Please wipe the surface well to make it clean and dry before intalling the LED strip lights. Hair, dust and other stuff may affect the stickiness of the tape.)

Location: DFW, TX