【UPGRADED】WP308180 W10308477 Oven Bake Element Replacement for Whirlpool Oven Heating Element WP308180 by Beaquicy - Suitable for Kenmore,Whirlpool ovens RF366PXXN2,FEP310EN0,RF365PXYN0,RF327PXVW,etc.

✔✔【???????????????? ???????????????????????????? ???????????????????????????????????? ????????????????】308180 WP308180 oven bake element is at the bottom of the oven and supplies the heat for baking. This bake element wp308180 is for ranges. The rated power is 2600 watts and the rated voltage is 240 volts. ►The size is approximately 16-5/8’’wide X 15-3/4"deep. ►The mounting bracket is 2" wide from the mounting bracket to the terminal end is 3". Mounting holes measure 1-3/4" apart center to center. ►package includes 1 x oven heating element wp308180
✔✔【???????????????????????? ???????????????????????????????????? ????????????????????】whirlpool oven element replacement 308180 oven bake element is made of HIGH TEMPERATURE RESISTANT NICKEL STAINLESS STEEL ALLOY, well-tested by manufacturer, and the product has a long service life. The terminals are nickel-plated, push-in type. ►If the following problems occur, then you can replace the 308180 Range Bake Element: ①If your oven heating element broke ②heats up inconsistently ③bottom oven heating element not working
✔✔【???????????????????????????????????????? ????????????????????】308180 Oven Bake Element is a standard heating element which fits most ovens that fits for Estate, Kenmore, Kitchen-Aid, Whirlpool, Roper Range ►Replaces 308180, 311470, 313827, 660576, 661170, 14210047, 308180BULK, 99989645, AP6007578, PS11740695, EAP11740695, rf3165xvw0, rf395pxxn0, rf395pxxn1, rf395pxxn2, rf363pxdn0, rf363pxdw0, rf363pxpt0, fep310bl0, fep310bl1, fep310bw0, fep310bw1, fep310yw0, fep310yw1, fep310yw2, fep314bl0, fep314bw0, fep320bl0, fes350bl0, etc
✔✔【???????????????????? ???????????????????????????????????????????? ???????? ???????????????? ????????????????】Unplug the range or shut off the house circuit breaker for the range before installing WP308180 Oven Bake Element. Wear work gloves to protect your hands. You should prepare a phillips screwdriver and pair of work gloves. Unscrewed the two screws that held the element in place, needed pliers to remove the sta-kon connectors from old element. Attached them to new element and put screws back in place.

Location: DFW, TX