KEMIMOTO KP6 UTV Tower Speakers 6.5" Woofers with 5.75" Passive Radiators | 520W MAX(130W RMS), Bi-Amp Drive, 3 preset EQ, Broadcast Sync, IP66 Waterproof for Off-Road & Marine, Fit for UTV/ATV/Boats

The KEMIMOTO KP6 speaker system boasts a distinctive, massive 5.75-inch passive radiator built into its rear pod, engineered for thunderous low-end response and impactful bass performance. At the front, the KP6 is equipped with a 6.5-inch mid-bass woofer and a 1-inch tweeter. This premium driver configuration allows the KP6 to outperform many 6.5-inch tower speakers — not to mention typical 4-inch soundbars. The result is tight, deep bass, robust midrange, and crisp, detailed high frequencies
Rotating Brackets: KEMIMOTO tower speakers come ready to mount with rotating brackets that fits 1.25" to 2" round roll bars—commonly found on UTV/ATV roll cages and boat railings. For overhead mounting, confirm your roof has at least 12mm of clearance above the roll bar before purchase. The brackets rotate 90° for flexible positioning across various vehicle mounting points. Note: Not work with square or profit tubes. Not fit 2-seat utility vehicles, 2-seat recreational UTVs, or golf carts without round bars
Louder Without the Distortion: KEMIMOTO UTV tower speakers feature a 520W Max Bi-Amp design for separate tweeter/woofer drive, keeping highs clear and lows powerful at high volume. Its 6-driver array (dual 6.5" woofers, 1" silk tweeters, 5.75'' passive radiators) with a 5.6L rear chamber pushes bass to 45Hz and treble past 20kHz. This separation gives vocals and bass their own space, creating a wide, layered soundstage—low-end thump hits your chest while lyrics stay crisp, whether accelerating or cruising
One-Touch Tuning: KEMIMOTO pod speaker packs a high-performance DSP with 3 preset EQ modes that you can switch instantly. Off-road mode boosts mids and highs against wind and engine noise. Bass boost mode improves deep, thumping lows for camp parties. Default mode keeps a balanced profile for low-speed cruising. Each mode reshapes the frequency curve like a pro tuned it on the spot, giving you the right sound whether you're blasting down a trail or kicking back at the campsite
Sync the Whole Group: KEMIMOTO UTV stereo system uses broadcast mode to sync over 100 broadcast-enabled speakers within an 82ft radius centered around the host unit. One press activates broadcast mode—compatible units link in seconds for synchronized playback. Picture multiple vehicles parked together at a campsite, or boats tied up at the dock—everyone sharing the same track in tight sync, turning the gathering into a single, immersive sound experience that fills the entire area
Built Tough for the Outdoors: KEMIMOTO UTV tower speaker is built for off-road environment with an IP66 waterproof housing that keeps mud and water out. Rain, mud, or a quick hose-down of the exterior won't stop the music. The shockproof structure handles heavy vibrations effectively. UV-resistant coating helps protect against sun damage. This is gear that keeps playing through the rough stuff, so you can keep your attention on the trail
Flexible Connectivity: KEMIMOTO UTV speaker supports wireless streaming, plus a weatherproof 3.5mm AUX input/output and USB port for lossless files from thumb drives. No cell signal in the backcountry? Plug in your USB library. You can even daisy-chain an active subwoofer for extra low-end. For good performance, start your engine before powering on the speaker to avoid voltage dips that can affect sound clarity, and turn off the power switch when the vehicle sits unused to save battery power
Product Dimensions: The KEMIMOTO UTV tower speaker measures 11.9"L x 7.7"W x 7.7"H per unit including the clamp, with the clamp itself at 1.2"L x 3.5"W x 2.4"H. The full set—two speakers, amplifier, and all mounting hardware—comes in at 17.4 lbs net weight. The 6.6 ft power cord gives you flexible routing options to keep wiring neat and out of the way. Everything you need arrives in one box, ready to mount and ride

Location: DFW, TX