Automatic Wire Stripper Machine,25W 0.04" - 0.79" Electric Wire Stripping Machine,with Free Replacement Blades,Portable cable stripper for Scrap Copper Wire Cable Recycling

25W Large Motor: ①【Faster】Compared with other wire stripping machines, the 10W motor has more high efficiency stripping and stable performance than 25W motor, maximizing productivity ②【Better】Low noise and fast heat dissipation during operation.③ The sharp blade made of high strength special alloy can quickly cut through the plastic or rubber insulation of the waste wire.
GREATER COMPATIBILITY: ①Our wire stripping tool has two different sized feeding holes, allowing wires in diameter 0.04"-0.79" (1mm~20mm).Meet your needs for wire stripping diameter sizes, which saves you time, effort and money. ②The position of the feed hole plate can be adjusted according to the wire diameter. ③Adjust the height of the blade according to the Thickness of the wire
Superior structure ： ① SENDUO wire stripper is made of high-quality and solid aluminum alloy, which is durable and greatly extends the service life of the machine. ② Hardened steel wheel - wear-resistant and durable, providing good protection for blade and operation. ③ We also provide you with additional replacement blades, so if the blades become less sharp, you can replace the blades, just use the supplied wrench. And it is easy to install on the workbench, workbench or workstation.
GREATER COMPATIBILITY: Our wire stripping tool has two different sized feeding holes, allowing wires in diameter 0.04"-0.79" (1mm~20mm), 2 mounting holes available. Blade can be adjusted up and down by twisting the regulating nut for cables in different sizes.
WIDELY USED ：Automatic wire stripper machine can strip round wire with diameter 0.04"~0.79".It is suitable for all kinds of hard-cover wire,soft-cover wire, multi-conductor wire,single filament wire and any other hard or soft wires.Instead of seeing it as a tool, you ought to think of it more as a great assistant in the workplace. Expectation-beyond wire stripping results and capability can always astound every customer.It's a must for copper wire recycling.
Note:① The blade should gently press against the wire to avoid adjusting it too deep,and damaging the wire core.②When feeding the wire, maintain an upward angle of approximately 10°-20° as it enters beneath the blade.Before inserting the wire into the feed hole, straighten it to ensure there are no knots or tangles. This significantly reduces feeding resistance.

Location: DFW, TX